Led Pattern - Mitsubishi Electric MSZ-AP22VGD Operating Instructions Manual

W
i-Fi INTERFACE SETTING UP (VGK TYPE ONLY)
7
Once completed, the MAC and ID will be fi lled in
'Add new unit'. Select 'Add' and then control your
heat pump via Wi-Fi.
Option 2 - WPS-Push Pairing
Please Note: The WPS and Router reset buttons may be
•
similar on some Routers.
• Please exercise caution as resetting your Router will erase
network confi guration.
3
Check Wi-Fi and WPS are enabled on your
Router. The connection procedure varies
depending on your Router – refer to your
Router's manual for more information.
4
Activate WPS Mode on your Router. This
will be enabled for a set period allowing
approximately 2 minutes to complete the next
step. To do so, please refer to your Router's
manual.
5
Activate WPS on your Wi-Fi interface by
using a small object to press and hold the
MODE Button for 2 seconds.
6
When WPS-Push is enabled on the Wi-Fi interface,
MODE LED starts fl ashing orange (every second).
7
When pairing process is completed on the Wi-Fi
interface, the NET LED lights up solid green for 5
seconds.
8
If ERR LED lights up orange for 5 seconds at any stage,
there may be a problem; please start process again.
9
Open Wi-Fi Control App. Enter MAC and ID into
'Add new unit' and select 'Add'.
10
Once completed, control your heat pump via Wi-Fi. Once completed, control your heat pump via Wi-Fi.

LED Pattern

ON OFF
: :
● Software initialising
Description
Firmware updating
Firmware downloading
Reset to the factory default
● Wireless setting
Description
Access Point Mode
activated
WPS-PUSH Mode activated
WPS-PIN Mode activated
ERR
NET Pairing process via WPS
MODE
completed
UNIT
Pairing process via WPS
RESET MODE
failed
● Connection to server in progress
Description
Communicating with server,
and starting up indoor unit
ERR
communication
NET
MODE
Communicating with server,
UNIT
and communicating with
RESET MODE
indoor unit
● Normal operation
Description
Communicating with server,
ERR and communicating with
NET
indoor unit
MODE
UNIT
(*1) Details of fl ash pattern
RESET MODE
• Every 0.5 sec: Searching for server.
• Every second: Registering the information of the Wi-Fi interface to server.
Flashing
:
ERR NET MODE
(Orange) (Green) (Orange)
(every (every
second) second)
ERR NET MODE
(Orange) (Green) (Orange)
(every 5
sec)
(every
second)
(every 0.5
sec)
(5 sec)
(5 sec)
ERR NET MODE
(Orange) (Green) (Orange)
(*1)
(*1)
ERR NET MODE
(Orange) (Green) (Orange)
(every 5
sec)
UNIT
(Green)
UNIT
(Green)
(every 5
sec)
UNIT
(Green)
(every 5
sec)
UNIT
(Green)
(every 5
sec)
En-14