Chapter 1 Basic Operation
For plastic card
• Depending on the operating environment paper jams or printing surface rubbing may occur. In such a case,
adjust the paper guides to the paper width.
However, when the paper guides are adjusted to the paper width, micro margin printing is not possible.
It is possible to check the amount of curl in
paper that is curled downward with the curl
When you place the paper with the printing
surface facing down as shown in the figure,
check that the index is not exceeded (the curl is
2 mm (0.08 inch) or less).
1. Flip through the two short edges of the
card to separate the cards.
When flipping through the card, do not touch
the printing surface with your fingers.
Flip through the two short edges of the card
thoroughly. If you have difficulty flipping
through the cards, flip through small numbers of
cards at a time.
Loading the card after flipping through it
prevent multiple cards from being fed at once.