FM 351 Parameterization
Introduction
You parameterize the positioning module with the parameterization software.
The software is intended for the FM 351 and the FM 451. The description of
operation can be found in the integrated help.
Requirements
Before you begin the parameterization of the FM 351 Positioning Function
Module, you should check the following requirements:
Installation
The complete software (parameterization software and function blocks) is
located on a 3.5 in. diskette. You install the software as follows:
1. Insert the diskette into the disk drive on your programming device/PC.
2. Under Windows 95 start the dialog on the installation of the software by
3. In the dialog select the disk drive and the file Setup.exe and start the
4. Step by step follow the instructions which the installation program dis-
Note
If you selected a folder other than STEP7_V2 for the STEP 7 installation,
this folder is recorded.
FM 351 Positioning Function Module
EWA 4NEB 720 6001-02
STEP 7 from V2.0 is correctly installed on your programming device/PC.
double clicking the symbol "Software" in "System Control".
installation process.
plays.
Result: The software is installed in the following folders:
– Function blocks: STEP7_V2\S7LIBS\FM_POS
– Example: STEP7_V2\EXAMPLES\FM_POSP
5
5-1