Download  Print this page

Computer Rack; Changing Computer Rack Door Orientation - Philips MX4000 System Installation Instructions

Hide thumbs

Advertisement

Computer Rack

Unpack the Computer Rack and roll it on its wheels to the Control Room.
NOTE
Verify that the front wheels are unlocked to enable free movement.
The front wheels on the Computer Rack have levers that lock the wheels. These will be engaged later after completing
cable connections to the Computer Rack.

Changing Computer Rack Door Orientation

The Computer Rack is supplied with left-hand door orientation. This section describes the procedure of changing the
orientation of the Computer Rack door to right-hand orientation if called for by the site layout.
Removing the Computer Rack Front Door
1 Use a Phillips screw driver to release the GND wire
screw on the Rack (see
Figure
39).
Release screw
Figure 39:
CSIP Level 0
© 2010 Koninklijke Philips Electronics N.V All Rights Reserved
Refer to Front Cover
39

Advertisement

Table of Contents

This manual is also suitable for:

Mx6000 dualMx4000 dual

Comments to this Manuals

Symbols: 0
Latest comments: