Condair Nortec GS  Series Quick Start Installation Manual

Condair Nortec GS Series Quick Start Installation Manual

Hide thumbs Also See for Nortec GS Series:

Advertisement

NORTEC
Quick Start Installation Guide
Gas
Combustion Air
Mounting
Plumbing
Electrical
Steam Distribution

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Nortec GS Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Condair Nortec GS Series

  • Page 1 NORTEC Quick Start Installation Guide Combustion Air Mounting Plumbing Electrical Steam Distribution...
  • Page 2: Installation Requirements

    5. All gas piping should be adequately supported to prevent any strain on inlet piping. * NOTE: Condair does not accept responsibility for 6. A 1/8” NPT plugged tapping, accessible for test gage installation code violations. connection, must be installed immediately upstream of the...
  • Page 3: Combustion Air

    See Figure 8: Location of air intake to the contaminants will also result in performance related and glue gas terminal must comply with all local and problems. Contact Condair technical services if you have any national regulations. questions. If contaminants exist, isolate the unit from the contaminated space.
  • Page 4 703/1360 (318/616) Mounting 4. Locate the humidifier as close as possible to the steam Mount either floor mounted or on a Condair supplied mounting distributor location, net output will be reduced as a result stand. of heat loss through the steam line. The steam distributor 1.
  • Page 5: Water Supply

    Chloride: 0-40 ppm * NOTE: All water supply and drain line connections should be installed in accordance with local plumbing codes. Condair does not accept responsibility for installation code violations. Drain Line(s) 1. Use ¾”O.D. drain lines from the unit to the air gap.
  • Page 6: Install Requirements

    Electrical Install Requirements 1. An external disconnect switch must be installed close to the in accordance with local codes or, in the absence of local unit to allow for power interruption during servicing and/or codes, with the National Electrical Code, ANSI/NFPA maintenance.
  • Page 7: Steam Distribution

    Install Requirements 1. The use of steam line other than copper, stainless steel tube or Condair supplied steam line will void the warranty and may 6. Support Steam line so weight is not on the unit. adversely affect the operation of the humidifier.
  • Page 8 All water supply and drain line connections must be installed in accordance with local plumbing codes by a licensed plumber. Condair does not accept any liability for installations of humidity equipment installed by unqualified personnel or the use of parts/ components/equipment that are not authorized or approved by Condair.

This manual is also suitable for:

Nortec gs 100Nortec gs 300Nortec gs 400Nortec gs 200Nortec gs 500Nortec gs 600 ... Show all

Table of Contents