Dräger X-Dock 5300 Technical Manual page 18

Menu
6.5.3 Exporting Station event logger
The saved data of the event memory can be saved to a
connected USB storage device with this function.
To copy data from the event memory to a USB data storage
device:
1. Connect the USB data storage device to the USB port on
the station.
The USB icon will appear in the status bar.
2. Select
> Data management > Station event logger.
The event memory is displayed.
3. Select the required files from the list.
4. Confirm selection with OK.
The selected files are copied onto the USB data storage
device.
6.5.4 Exporting data memory
The saved data of the data memory can be saved to a
connected USB storage device with this function.
To copy data from the data memory to a USB data storage
device:
1. Connect the USB data storage device to the USB port on
the station.
The USB icon will appear in the status bar.
2. Select
> Data management > Export data logger.
The data memory is displayed.
3. Select the required files from the list.
4. Confirm selection with OK.
The selected files are copied onto the USB data storage
device.
6.5.5 Exporting certificates
This function can be used to save the stored certificates to a
connected USB storage device.
To copy certificates to a USB data storage device:
1. Connect the USB data storage device to the USB port on
the station.
The USB icon will appear in the status bar.
2. Select
> Data management > Export certificates.
The event memory is displayed.
3. Select the required certificates from the list.
4. Confirm selection with OK.
The selected certificates are copied onto the USB data
storage device.
6.5.6 Mobile synchronization
This function can be used to copy the local database, reports,
certificates and device data loggers to a connected USB
storage device or the internal MSD area. This is useful if the
data cannot be exchanged via the network connection. The
data can then be imported into the X-dock Manager (see
X-dock Manager Online Help).
1. If necessary, connect the USB storage device to the USB
port on the station.
2. Select > Data management > Mobile synchronization .
The available target locations are displayed.
3. Select desired target location.
18
4. Confirm the selection with OK.
The data is copied to the target location.
NOTICE
i i
Dräger recommends cleaning the local data after
successfully importing the data into the database (see
chapter 6.4.4 on page 17).
Dräger recommends exporting the local data on a
regular basis to keep the amount of data to be
exported, and thus copied, small.
The export via the MSD area is faster than via a USB
storage device.
6.5.7 Activating or deactivating MSD mode
This function allows the station to be used as a USB mass
storage device and the data saved in the station can be copied
to a connected PC.
To activate MSD mode:
1. connect PC with USB mini B cable to the X-dock.
2. Select
> Data management > MSD mode.
3. Activate MSD mode.
4. Confirm setting with OK.
The station is now visible on the PC as a drive.
NOTICE
i i
No other actions can be performed with the station
while MSD mode is active.
To deactivate MSD mode:
Cancel MSD mode with X.

The station is ready for operation again.
Dräger X-dock 5300/6300/6600