Deleting (Application) Peaks; Calling The Quick Menu; Opening Information - Dräger HFG 000 Series Technical Manual

Operation
If the measuring range is exceeded significantly at the CatEx channel (very high
concentration of flammable materials), a blocking alarm is triggered. This CatEx
blocking alarm can be acknowledge by switching the gas detector off and then on
again in fresh air.
X-am 8000 only: This does not apply in the case of an activated over range for
methane.
4.7.5

Deleting (application) peaks

1. Select
2. Select Clear app. peak and confirm the dialog.
The function must be activated in the quick menu. Alternatively, this function can
also be called via the menu.
4.8

Calling the Quick Menu

The Dräger CC-Vision software can be used to save up to 6 preferred features.
The following features are default settings:
– Device information
– Switch between day and night mode
– Display messages
– Display shift peaks
– Display application peaks
– Delete application peaks
To open the quick menu:
1. Select
2. Select and confirm the desired feature.
4.9

Opening information

1. Select
The following options are available:
Option
Messages
Device information
24
in measuring mode.
in measuring mode.
> Info in measuring mode.
Description
The pending warnings and errors are
displayed.
Device information and information
about the Bluetooth® module (optional,
X-am 8000 only) is displayed (e.g. MAC
address, serial number, firmware ver-
sion etc.).
|
Technical manual X-am® 3500/8000