Maintenance; Cleaning And Preventative Maintenance - Market Forge Industries TURBO STEAM SERIES Installation Operation & Maintenance

Cleaning and Preventative Maintenance

A good preventive maintenance program begins with the
daily cleaning procedure. For other installations, tasks re-
quiring mechanical or electrical experience should only
be performed by an authorized service agency.
The following paragraphs are set for minimum preventive
maintenance procedures that must be completed peri-
odically to assure continued trouble-free operation of the
cooker.
CAUTION
Under no circumstances should hardware
(or parts) be replaced with a different length,
size, or type other than as specified in the
parts list. The hardware used in the cooker
has been selected or designed specifically for
its application, and the use of other hardware
may damage the equipment and will void any
warranty.
WARNING
Disconnect the power supply to the appliance
before cleaning or servicing.
WARNING
The steamer and its parts are hot. Use care
when operating, cleaning or servicing the
steamer. The cooking compartment contains
live steam. Stay clear when opening door.
CLEANING
At the end of each day, or between cooking cycles if nec-
essary:
CAUTION
Do not use cleaning agents that are corrosive.
Never spray water into electric controls or
louvers
NOTE: Contact the factory, the factory representative or
a local service company to perform maintenance
and repairs should the appliance malfunction. Re-
fer to warranty terms.
Daily
After each period of daily operation (more frequently as
required to maintain cleanliness), the cooker should be
thoroughly cleaned by completing the following steps:
1. Perform SHUTDOWN procedure.
2. Remove the deflector plate and pan supports by lift-
ing up and off mounting studs and wash with a mild
detergent. Rinse and set aside for reassembly.

MAINTENANCE

3. When the unit has cooled, use hot soapy water to
clean the interior of the steamer and thoroughly rinse
and dry all surfaces with a clean dry cloth.
4. Inspect the drain opening to assure there are no ob-
structions.
5. Replace the pan supports and deflector in compart-
ment and leave door ajar.
Weekly, or more often if necessary:
1. Clean exterior with a damp cloth and polish with a soft
dry cloth.
2. Use a non-abrasive cleaner to remove discolorations.
It is NOT RECOMMENDED to use cleaning agents
that are corrosive.
Use of cleaning agents that contain chloride, acids
or salts which are corrosive may cause pitting and
corrosion when used over a period of time; this will
reduce the life of the appliance.
Pitting or corrosion is not covered by warranty.
Follow the recommended cleaning instructions. Use
a mild detergent, warm water and rinse thoroughly.
WARNING
When installed with casters and connected
to the supply service with flexible electrical
conduit, a restraint to prevent damage to the
electrical conduit should have been installed.
If disconnection of the restraint is necessary,
reconnect after the appliance has been re-
turned to its originally installed position.
8