Related Manuals for Smeg CH500
Summary of Contents for Smeg CH500
- Page 1 CH300, CH400, CH500 Instructions for use. Bedienungsanleitung Mode d’emploi Brugsanvisning Bruksanvisning Genruiksaanwijzing...
-
Page 2: Warning
Warning In case this appliance contains hydrocar- bon refrigerant please refer to guidelines listed below. As the appliance contains a flammable refrigerant, it is essential to ensure that the refrigerant pipes are not damaged. Standard EN378 specifies that the room in which you install your appliance must have a volume of 1m³... -
Page 3: Table Of Contents
Contents Warning ...2 Before use ...3 Get to know your chest freezer... 4 Installation and start-up..5 Electrical connection... 6 Operation and function ... 7 Use ...8 Defrosting ...9 Cleaning and maintenance ... 10 Fault finding ... 11 Warranty, spare part and service..12 Disposal. -
Page 4: Get To Know Your Chest Freezer
Get to know your chest freezer Handle Lamp Sealing strip Nameplate Partition/defrost water tray Basket Frezing compartment Ventalation grille Mechanical control panel Defrost water drain CONTROL SUPER Foot fig. 1... -
Page 5: Installation And Start-Up
Installation and start-up Placement For safety and operational reasons, the ap- pliance must not be installed outdoors. The appliance should be placed on a stable, level surface in a dry, well-ventilated room (max. 75% relative air humidity). Never place the appliance close to sources of heat such as cookers or radiators, and avoid placing it in direct sunlight. -
Page 6: Electrical Connection
Technical data This device complies with relevant EU directives including Low Voltage Directive 2006/95 EEC. and Electromagnetic Com- patibility Directive 2004/108/EC The rating plate provides various techni- cal information as well as type and serial number. Electrical connection The appliance is intended for connection to alternating current. -
Page 7: Operation And Function
The green lamp lights up to indicate that power is supplied. The red lamp on the con- trol panel will also light up to indicate that the temperature inside the freezer is not yet sufficiently low. Temperature setting The temperature is set by turning the thermostat knob from MIN to MAX. -
Page 8: Use
To thaw meat, it is advisable to take it out of the freezer the day before it is to be used and place it in a refrigerator to defrost. This ensures the best hygiene and maintains meat quality as much as possible. -
Page 9: Defrosting
The items stored and the humidity of the air gradually cause frost and ice to form in the freezer. A thin layer of frost or ice does not affect freezer performance, but the thicker the layer, the higher the energy consump- tion. -
Page 10: Cleaning And Maintenance
5 mm thick. ● Do not open the lid more than necessary. ● Cool hot food and beverages before plac- ing them in the freezer. Replacing the bulb 1. Disconnect the power supply by pulling the plug out of the socket. -
Page 11: Fault Finding
Reposition items inside the freezer and check that the lid closes tightly. Ventilate the room more often or move the freezer to a room with lower humidity. Repack items stored in the freezer. Wait 2-3 minutes until the underpressure has been equalised and try again. -
Page 12: Warranty, Spare Part And Service
Warranty, spare parts and service Warranty disclaimer Faults and damage caused directly or indirectly by incorrect operation, misuse, insufficient maintenance, incorrect building, installation or mains connection. Fire, ac- cident, lightening, voltage variation or other electrical interference, including defective fuses or faults in mains installations are not covered by the warranty. -
Page 13: Disposal
Disposal Information for Users on Collection and Disposal of Old Equipment and used Batteries These symbols on the products, packaging, and/or accompanying documents mean that used electri- cal and electronic products and batteries should not be mixed with general household waste. For proper treatment, recovery and recycling of old products and used batteries, please take them to applicable collec-...