Sprayer Controls - WAGNER Control Painter Owner's Manual

SPraYer ControlS

For a video showing Control Painter spraying tips and best practices, visit:
i
www.wagnerspraytech.com/controlpainter
Material Flow Control
The material flow control will be factory-set
i
at its lowest setting out of the box. Adjust as
needed.
•
Turn the knob out (counterclockwise) for less flow.
Generally, low material flow is needed for spraying smaller
surface areas, such as corners, lattice, or spindles.
•
Turn the knob in (clockwise) for increased flow. Generally,
high material flow is needed for spraying large surface
areas, such as fences and decks.
Pattern aDjUStMent
Adjust the spray pattern by turning the air cap
i
ears. The air cap position will determine the
movement direction of the spray gun.
The spray width lever on the iSpray nozzle
determines the width of the spray pattern.
1.
Vertical pattern:
Use side-to-side motion during spraying.
2.
Horizontal pattern:
Use up and down motion during spraying.
3.
Narrow pattern (set spray width lever to narrow):
Use up and down, or side to side spraying motion,
depending upon the object being sprayed.
8
2
SPraY wiDth lever
air CaP
air CaP earS
1
3
=
=
en
=
=
=