Related Manuals for Smeg Vitroceramic Cooking Hob SE631CX
Summary of Contents for Smeg Vitroceramic Cooking Hob SE631CX
- Page 1 ENCIMERAS DE COCCIÓN VITROCERÁMICAS VITROCERAMIC COOKING HOBS PIANI DI COTTURA IN VETROCERAMICA TABLES DE CUISSON VITROCÉRAMIQUES GLASKERAMIK-KOCHFELDER KERAMISCHE KOOKPLATEN...
- Page 2 Página Page 10-16 Pagina 17-23 Page 24-30 Seite 31-37 Bladzijde 38-44...
- Page 3 Introduction Description Model SE 640 (see fig. 1) 1 Heating element of 1.200 W. 2 Heating element of 1.800 W. 3 Heating element of 1.800 W. 4 Heating element of 1.200 W. 5 Residual heat indicators. • Maximum electric power: 6.000 W. Model SE 631 (see fig.
-
Page 4: Installation
Installation Note THE INSTALLATION AND FITTING WORK MUST BE CARRIED OUT BY AN AUTHORISED INSTALLATION TECHNICIAN ACCORDING TO APPLICABLE REGU- LATIONS. Selecting a location for the hob (see fig. 3) To install these hobs, a hole with the dimen- sions specified in the figure, must be cut out of the top of the work surface furniture. -
Page 5: Technical Data
replaced by the manufacturer since special tools are required. Avoid the mains cable resting against the hob or oven casing oven if installed in the same piece of furniture. Note: • The adhesives used in the manufacture of the furniture or for applying decorative laminas or the surface layer of the work top must be able to withstand temperatures of up to 100 •... -
Page 6: Use And Maintenance
Use and Maintenance Using vitroceramic hotplates Each of the vitroceramic hob's heating ele- ments is connected to an energy compensator which controls the operating and stopping time for each one (more or less heat). (See fig. 6). The hob is switched off when at "0", at "1" the operating time is shor t and the stopping time long. - Page 7 the hotplate outlines marked on the glass. • Dry the bases of pots before placing them on the vitroceramic hob top. • Never leave plastic objects or utensils, or aluminium foil on the vitroceramic hob. • Take care not to scrape the surface of the hob with pots with sharp edges or corners.
-
Page 8: Recommended Cleaning Products
RECOMMENDED CLEANING PRODUCTS Product Gentle liquid detergents Powder or aggressive detergents Special vitroceramic cleaners Grease removal sprays (ovens, etc.) Soft cleaning cloths Kitchen roll Dish cloths Nickel cleaning pads (never dry) Steel cleaning pads Hard (green) synthetic cleaning pads Soft (blue) synthetic cleaning pads Scrapers for glass Liquid polish for domestic equipment and / or glass... -
Page 9: Frame Maintenance
Deterioration of surface markings is caused by using abrasive cleaning products or reci- pients with irregular bases that scrape off the silk-screened markings. Pots may stick to the sur face due to a subs- tance melting between them. Never try to pull the pot away when cold! This could break the glass.