Connecting To The Epson S5U13U00P00C100 Usb Adapter Board - Epson S5U13515P00C100 User Manual

For s2d13515 display controller
Table of Contents

Advertisement

Chapter 4 Technical Description

4.5.2 Connecting to the Epson S5U13U00P00C100 USB Adapter Board

The S5U13515P00C100 evaluation board is designed to connect to a S5U13U00P00C100 USB Adapter Board. The
USB adapter board provides a simple connection to any computer via a USB 2.0 connection. The
S5U13515P00C100 directly connects to the USB adapter board through connectors P1 and P2.
The USB adapter board also supplies the 3.3V power required by the S5U13515P00C100 evaluation board.
HIOVDD should be configured for 3.3V and JP7 should be set to the 2-3 position.
When the S5U13515P00C100 is connected to the S5U13U00P00C100 USB Adapter board, there are 2 LEDs on the
S5U13515P00C100 which provide a quick visual status of the USB adapter. LED1 blinks to indicate that the USB
adapter board is active. LED2 turns on to indicate that the USB has been enumerated by the PC.
The following diagram shows the location of connectors P1 and P2. P1 and P2 are 2mm x 2mm, 40-pin headers
(20 x 2) located on the underside of the board.
Figure 4-3: USB Adapter Connector Locations (P1 and P2)
For the pinout of connectors P1 and P2, see Section Chapter 6, "Schematic Diagrams" on page 29.
Note
A windows driver must be installed on the PC when the S5U13515P00C100 is used with the S5U13U00P00C100
USB Adapter Board. The S1D13xxxUSB driver is available at www.erd.epson.com.
18
EPSON
S5U13515P00C100 Evaluation Board User Manual (Rev 1.1)

Advertisement

Table of Contents
loading

Table of Contents