Epson S5U13515P00C100 User Manual page 11

For s2d13515 display controller
Table of Contents

Advertisement

JP1, JP2, JP3, JP4, JP5, JP6, JP10, JP11, JP14, JP15 - Power Supplies for the S2D13515
JP1, JP2, JP3, JP4, JP5, JP6, JP10, JP11, JP14, and JP15 can be used to measure the current consumption of each
S2D13515 power supply.
When the jumper is at position 1-2, normal operation is selected.
When no jumper is installed, the current consumption for each power supply can be measured by connecting an
ammeter to pin 1 and 2 of the jumper.
The jumper associated with each power supply is as follows:
JP1 for COREVDD
JP3 for PLL2VDD
JP5 for PIO1VDD
JP10 for CM1VDD
JP14 for IOVDD
Figure 3-3: Configuration Jumper Locations (JP1, JP2, JP3, JP4, JP5, JP6, JP10, JP11, JP14, JP15)
S5U13515P00C100 Evaluation Board User Manual (Rev 1.1)
JP2 for PLL1VDD
JP4 for OSCVDD
JP6 for HIOVDD
JP11 for PIO2VDD
JP15 for SDVDD
EPSON
Chapter 3 Installation and Configuration
11

Advertisement

Table of Contents
loading

Table of Contents