Advertisement
Important Safety Instruction
IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS – Your safety and the safety of others are very important.
We have provided many important safety messages throughout this manual and on the appliance.
Read all instructions before using the appliance and always obey all safety messages.
RECOGNIZE SAFETY INFORMATION
This is a safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and
others.
UNDERSTAND SIGNAL WORDS
A signal word – DANGER, WARNING, or CAUTION – is used with the safety alert symbol. DANGER
identifies the most serious hazards. It means you can be killed or seriously injured if you do not
immediately follow the instructions. WARNING means you can be killed or seriously injured if you do not
follow the instructions. CAUTION indicates a potentially hazardous situation which, if not avoided, may
result in minor or moderate injury.
All safety messages will inform you of potential hazards, on how to reduce the risk of injury and what
can occur if the instructions are not followed.
IMPORTANT: Observe all governing codes and ordinances.
WARNING: For your safety, the information in this manual must be followed to minimize the risk
of fire or explosion, or to prevent property damage, personal injury or death.
-
This conversion kit must be installed by a qualified service agency in accordance with the
manufacturer's instructions and all applicable codes and requirements of the authority
having jurisdiction.
-
The qualified service agency is responsible for the proper installation of this kit.
-
The installation must not be considered to be correct and completed until the operation of the
converted appliance is checked as specified in the manufacturer's instructions supplied with
this kit.
FIRE HAZARD
WARNING
Securely tighten all gas connections. If connected to LP, have a qualified
person ensure that the gas pressure does not exceed 14" water column.
Examples of a qualified person include licensed heating personnel,
authorized gas company personnel, and authorized service personnel.
FAILURE TO DO SO CAN RESULT IN DEATH, EXPLOSION, OR FIRE.
3
Advertisement
Table of Contents
Related Manuals for Smeg PTS605BU3
Summary of Contents for Smeg PTS605BU3
-
Page 1: Important Safety Instruction
Important Safety Instruction IMPORTANT SAFETY INSTRUCTIONS READ AND SAVE THESE INSTRUCTIONS – Your safety and the safety of others are very important. We have provided many important safety messages throughout this manual and on the appliance. Read all instructions before using the appliance and always obey all safety messages. RECOGNIZE SAFETY INFORMATION This is a safety alert symbol. - Page 2 W.C. Supply pressure of 8” - 13” W.C. maximum. The cooktop must be isolated from the gas supply piping system by closing the respective manual shut- off valve during any pressure testing of the gas supply piping system at test pressures equal to or greater than 1/2 psig (3.5 kPa).
- Page 3 Fig. 4). • the burners and gas taps can only be accessed by pushing the rear of the cooktop gently upwards with the aid of a tool (9-10, Fig. 5). This is necessary to release the internal snap fixing devices. The cooktop's upper surface can now be removed.
- Page 4 To adjust the cooktop for LP gas or to return to Natural Gas use, refer to the tables below. PTS605U - Natural gas Injector Ø mm Left Central 14000 1.60 Central 3400 0.80 Front Central 6000 1.05 Rear Right 9000 1.26...
-
Page 5: Fire Hazard
Caution: refit all flame caps in the same points from which they were removed. In fact, the flame cap positions cannot be changed. After refitting them, ensure that they are perfectly positioned and that there is no clearance between the cooktop and the flame caps. FIRE HAZARD... -
Page 6: Natural Gas
Make sure that the shut-off valve is on the "ON" position. Check operation again. If a burner does not light at this point, contact your SMEG dealer for assistance. Replace the components on the burner and turn the knobs on the gas tap pins.
Need help?
Do you have a question about the PTS605BU3 and is the answer not in the manual?
Questions and answers