Download  Print this page

Husqvarna W 40P Workshop Manual page 8

Hide thumbs

Advertisement

Prepare and do servicing on the product
8. lf the choke lever was moved to the CLOSED posi-
tion to start the engine, gradually move it to the
OPEN position as the engine warms up.
CLOSED
Figure 9
3.2.3 To set the engine speed
After starting the engine, move the throttle lever (G)
to the FAST position for self-priming, and check pump
output. Pump output is controlled by adjusting engine
speed. Moving the throttle lever in the FAST direction
will increase pump output, and moving the throttle lever
in the SLOW direction will decrease pump output.
Figure 10
3.2.4 To stop the product
To stop the engine in an emergency, simply turn the
ignition switch (H) to the OFF position. Under normal
conditions, use the following procedure.
1. Move the throttle lever (G) to the SLOW position.
Figure 11
8 - English
F
OPEN
SLOW
G
FAST
SLOW
G
FAST
2. Turn the ignition switch (H) to the OFF position.
OFF
Figure 12
3. Turn the fuel valve lever (E) to the OFF position.
OFF
Figure 13
After use, remove the pump drain plug and drain the
pump chamber. Remove the filler cap, and flush the
pump chamber with clean, fresh water. Allow the water
to drain from the pump chamber, and then reinstall the
filler cap and drain plug.
3.2.5 To add fuel to the product
WARNING: Gasoline is highly flammable
and explosive. You can be burned or seri-
ously injured when handling fuel.
Stop the engine and keep heat,
sparks, and flame away.
Handle fuel only outdoors.
Wipe up spills immediately.
ON
H
E
ON

Advertisement

Table of Contents
loading

  Also See for Husqvarna W 40P

  Related Manuals for Husqvarna W 40P