Installation Into A Rack - Lenovo Campus Series Installation Manual

Installation into a Rack

1. Place the switch on a flat horizontal surface.
2. Position the frontal rack-mount bracket over the screw holes on the side of the
3. Use the frontal rack-mount screws and the Phillips-head screwdriver to fasten the
4. Repeat steps 1 to 3 for the other frontal rack-mount bracket on the other side of the
22
CE0128TB/CE0128PB/CE0152TB/CE0152PB Installation Guide
Switches in this series can be mounted in a standard 19 inch rack using the provided
mounting brackets. The following section explains how to install the rack-mount
brackets onto the switch and then mount the switch into a standard rack-mount
unit.
The following parts are used to install the switch into a rack-mount unit:
One pair of rack-mount brackets

 Eight Phillips-head rack-mount bracket screws
Additional equipment needed to install the switch into a rack-mount unit:
One Phillips-head screwdriver. This screwdriver is used for the rack-mount

bracket screws.
 One additional screwdriver. This screwdriver is used for the rack-mount unit
screws and its type and size depends on the rack-mount unit screws being used.
 Four rack-mount unit screws. These screws are used to attach the switch onto to
the rack-mount unit and are not included in the switch's packaging as
rack-mount units differ at each installation site.
 Four rack-mount unit cage nuts. These cage nuts are used to attach the switch
onto to the rack-mount unit and are not included in the switch's packaging as
rack-mount units differ at each installation site.
The figure below illustrates how to install the frontal rack-mount brackets onto the
switch:
switch. The ears of the bracket must be facing forward and outwards.
bracket onto the side of the switch.
switch.