Lenovo ThinkServer TS150 User Manual And Hardware Maintenance Manual page 10

Statement 12
DANGER
Overloading a branch circuit is a potential fire hazard and a shock hazard under certain conditions. To avoid
these hazards, ensure that your system electrical requirements do not exceed branch current ratings at the
installation site.
Statement 13
CAUTION:
Ensure that the rack is secured properly to avoid tipping when the server unit is extended on the rails.
Statement 14
CAUTION:
Some accessory or option board outputs exceed Class 2 or limited power source limits. You must
install the appropriate interconnecting cabling in accordance with your local electrical code
requirements.
Statement 15
CAUTION:
The power-control button on the device may put the device in standby mode instead of turning off the
device. In addition, the device might have multiple connections to dc power. To remove all electrical
current from the device, ensure that all connections to dc power are disconnected at the dc power
input terminals.
Statement 16
CAUTION:
To reduce the risk of electric shock or energy hazards:
• This equipment must be installed by trained service personnel in a restricted-access location, as
defined by your local electrical code and the latest edition of IEC 60950.
• The branch circuit overcurrent protection must be rated in accordance with local electrical code
requirements.
2
• Use 1.3 mm or 16 American Wire Gauge (AWG) copper conductor only, not exceeding 3 meters in
length.
viii