HP M8501 Installation And User Manual page 68

Troubleshooting
Table 6-2. Fault Symptom Codes
Message
SMX send error
SMX receive error
Comm free list empty
Invalid comm. put
attempt
Invalid comm. get
attempt
Comm initialization
error
Put of a NULL comm.
Msg contains no
comm.
Comm return address
in unknown
Bad Image CRC
Flash erase sector
failed
Flash program sector
failed
Bad flash CRC
Flash exit error
Incompatible image
Buffer allocation failed
M8501 and M8502 ACL Tape Drive Installation and User's Guide —529972-001
FSC ERP
A001 C, G
A002 C, G
A003 C, G
A004 C, G
A005 C, G
A006 C, G
A007 C, G
A008 C, G
A009 C, G
F001 F
F002 F
F003 C, G
F004 C, G
F005 C, G
F006 F
F402 F
6- 12
Fault Symptom Codes (FSCs)
An attempt to place a message on a
task's exchange generated a kernel error.
An attempt to receive a message from a
task's exchange generated a kernel error.
An attempt to acquire a message from the
free pool failed because the pool is empty.
An attempt to place a message on a
task's exchange failed because either the
argument message pointer was NULL or
the argument exchange pointer was
NULL.
An attempt to receive a message from a
task's exchange failed because the
argument exchange pointer was NULL.
The Comm manager could not be
initialized at power-up because the
system is out of memory.
An attempt to place a Comm block on a
task's exchange failed the argument
Comm block pointer was NULL.
A message obtained from the free pool
did not contain a Comm block.
An attempt to return a command
response to the originating task failed
because the originator could not be
determined.
The uploaded firmware image has a bad
CRC and is probably corrupted.
One of the flash memory sectors could
not be programmed.
One of the flash memory sectors could
not be erased.
The firmware image programmed into
flash memory has a bad CRC and is
probably corrupted.
Internal flash task error.
The uploaded firmware image is not
compatible with the ACL hardware,
possibly an older firmware version.
The flash task could not allocate a buffer
area to hold the firmware image to be
uploaded.