Advertisement
Quick Links
Model
LP121HT
Updated 3/98
Triplex Ceramic
Plunger Pump
Operating Instructions/
Repair and Service
Manual
Contents:
Installation Instructions: page 2
Pump Specifications:
Exploded View:
Parts List / Kits:
Torque Specifications:
Operating Instructions:
Repair Instructions:
Dimensions:
Warranty Information:
page 3
page 4
page 5
page 5
page 6
pages 7
back page
back page
Advertisement
Related Manuals for Giant LP121HT
Summary of Contents for Giant LP121HT
- Page 1 Triplex Ceramic Plunger Pump Model Operating Instructions/ Repair and Service Manual LP121HT Contents: Installation Instructions: page 2 Pump Specifications: page 3 Exploded View: page 4 Parts List / Kits: page 5 Torque Specifications: page 5 Operating Instructions: page 6 Repair Instructions:...
-
Page 2: Installation Instructions
The use of a there are some basic steps common to all dampener with Giant Industries, Inc. pumps is pumps. The following information is to be optional, although recommended by Giant considered as a general outline for installa- Industries, Inc. -
Page 3: Exploded View
The desired pressure is achieved by selecting the use the following formula: correct nozzle size that corresponds with the pump (GPM X PSI)/1450 = HP GPM. LP121HT PULLEY SELECTION AND HORSEPOWER REQUIREMENTS 300 PSI 600 PSI 900 PSI 1200 PSI 12.4... -
Page 4: Crankcase 1
EXPLODED VIEW - LP121HT PUMP Item Part Description Qty. PARTS LIST - LP121HT PUMP 07759 Crankcase... - Page 5 PARTS LIST - LP121HT PUMP Item Part Description Qty. Item Part Description Qty. 07759 Crankcase 13233 Flinger 13000 Oil Filler Plug Assy. 06120 Seal Retainer, Complete 06085 Crankcase Cover (#31A, 32, 32A, & 33) 3 07104 O-Ring 06118 Oil Seal 07186 Oil Sight Glass Assy.
- Page 6 Supplementary Plant Lay-Out Instructions - LP121HT PUMP Pressure in Inlet Side The stipulated NPSHR is the minimum required pressure above the vapor pressure of the medium and is never to fall short of this figure. Temperature and vapor pressure of the medium, the geodetical height of the location, the flow rate and the loss of friction in the suction line, must all be taken into consideration.
-
Page 7: Screw 4
0.15mm by placing fitting discs (20A and 20B) under the bearing cover. Caution: After assembly, the crankshaft (22) should turn easily with very little clearance. Tighten connecting rod screws (24) to 310 in.-lbs. NOTE: Contact Giant Industries for Service School Information. Phone: (419)-531-4600... -
Page 8: Washer
A Returned Goods Authorization (R.G.A.) number and completed warranty evaluation form is required prior to the return to Giant Industries of all products under warranty consideration. Call (419)-531-4600 or fax (419)-531-6836 to obtain an R.G.A. number.