Husqvarna Rider 316T Operator's Manual page 21

Hide thumbs Also See for Rider 316T:
Table of Contents

Advertisement

Available languages

Available languages

To replace a broken lamp
1. Remove the 2 screws and remove the lamp cover.
2. Disconnect the cables from the broken lamp.
3. Carefully push in the lock mechanism and tilt the
lamp to remove it from the brackets.
4. Put the new lamp in the lower slot on the lamp
housing. Use the type of lamp as given in
data on page 30 .
517 - 001 - 17.01.2018
5. Press the lamp into the lock mechanism.
6. Put the lower end of the lamp cover into the slots on
the servo housing.
7. Connect the cables to the new lamp.
8. Attach the cover and tighten the screws.
To charge the battery
Technical
Charge the battery if it is too weak to start the
engine.
Use a standard battery charger.
Always disconnect the charger before starting the
engine.
To do an emergency start of the engine
If the battery is too weak to start the engine, you can use
jumper cables to do an emergency start. This product
has a 12 V system with negative ground. The product
that is used for the emergency start must also have a 12
V system with negative ground.
CAUTION: Do not use a boost charger
or start booster. That will cause damage
to the electrical system of the product.
21

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rider 316t awdRider 316ts awdRider 316txs awd

Table of Contents