Assembly - Husqvarna Rider 316T Operator's Manual

Hide thumbs Also See for Rider 316T:
Table of Contents

Advertisement

Available languages

Available languages

Explosive gases can come from the battery. Do not
smoke near the battery. Keep the battery away from
open flames and sparks.
Safety instructions for maintenance
WARNING: If the product is not parked
correctly and the engine and ignition is not
off, it can cause injury or damage to property
or the adjacent area. Do not do maintenance
on the engine or cutting deck unless the
conditions that follow are met:
The engine is off.
The product is parked on a level surface.
The parking brake is applied.
The ignition key is removed.
The cutting deck is disengaged.
The ignition cables are removed from the
plugs.
WARNING: The exhaust fumes from the
engine contain carbon monoxide, an
odourless, poisonous and very dangerous
gas. Do not run the product indoors or in
closed spaces.
WARNING: Read the warning instructions
that follow before you use the product.
Introduction
WARNING: The drive belt tension spring can
break and cause injury. Wear protective
glasses when you attach or remove the
cutting deck.
Read the assembly instructions in the owner's manual
carefully. A label on the inner side of the front cover on
the product, also shows how to attach and remove the
cutting deck.
To attach the cutting deck
1. Park the product on level ground.
2. Apply the parking brake.
3. Set the cutting height lever in the servicing position.
4. Set the lift lever for the cutting deck in mow position.
10
For best performance and safety, do maintenance
on the product regularly as given in the maintenance
schedule. See
Electrical shocks can cause injuries. Do not touch
cables when the engine is on. Do not do a function
test on the ignition system with your fingers.
Do not start the engine if the protective covers are
removed. There is a high risk of injury caused by
moving or hot parts.
Let the product become cool before you do
maintenance in the engine compartment.
The blades are sharp and can cause cuts. Wind
protection around the blades or wear protective
gloves when you do work on them.
CAUTION: Read the caution instructions
that follow before you use the product.
Do not turn over the engine if the spark plug or
ignition cable has been removed.
Make sure that all nuts and bolts are tightened
correctly and that the equipment is in good condition.
Do not change the adjustment of governors. If you
run too fast, you risk damage to the machine
components. See
highest permitted engine speed.
The product is approved only with the equipment
supplied or recommended by the manufacturer.

Assembly

5. Push the equipment frame down. Lift the equipment
frame lock to vertical position.
Maintenance schedule on page 16 .
Technical data on page 30 for
WARNING: The lock mechanism can
cause injury to fingers if you do not
operate it carefully. Put the equipment
frame lock in full vertical position.
517 - 001 - 17.01.2018

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rider 316t awdRider 316ts awdRider 316txs awd

Table of Contents