Electrolux EEC5700 User Manual page 27

The pyrolytic cleaning
procedure cannot start:
• if you did not fully close
the oven door. In some
models, the display shows
"C3" when this error
occurs.
CAUTION!
If there are other appliances
installed in the same cabinet,
do not use them at the same
time as the Pyrolysis function.
It can cause damage to the
appliance.
During the pyrolytic cleaning the door is
locked. The symbol
heat indicator come up, until the door
unlocks. The door unlocks when the
temperature inside the oven is under
safety conditions and the pyrolytic
cleaning finishes.
During the pyrolytic cleaning the lamp is
deactivated.
1. Remove the worst dirt manually.
2. Clean the inner side of the door with
hot water, so that the residues do not
burn from the hot air.
3. Activate the appliance.
4. Touch again and again until the
display shows "Pyro" and the number
of the cleaning programme.
5. Touch or
the cleaning procedure:
Option
1
2
3
You can use the End function to delay
the start of the cleaning procedure.
and the bars of the
to set the duration of
Description
1:00 h for a
low degree of
dirt
1:30 h for a
usual degree
of dirt
2:30 h for a
high degree
of dirt
6. Touch to activate the Pyrolysis
function.
11.5 Cleaning reminder
To remind you that the pyrolytic cleaning
is necessary, the cleaning reminder
symbol flashes in the display after each
deactivation of the appliance for the next
10 seconds.
The cleaning reminder
goes out:
• after the end of the
pyrolytic cleaning.
• when you deactivate it in
the basic settings. Refer
to "Using the settings
menu".
11.6 Cleaning the oven door
The oven door has four glass panels. You
can remove the oven door and the internal
glass panels to clean them.
The oven door can close if
you try to remove the glass
panels before you remove the
oven door.
CAUTION!
Do not use the appliance
without the glass panels.
1. Open the door fully and hold the two
door hinges.
2. Lift and turn the levers on the two
hinges.
ENGLISH 27