Download  Print this page

System-on-module (som) Pca - Philips Efficia DFM100 Service Manual

Defibrillator/monitor.
Hide thumbs

Advertisement

Internal Assemblies — Main Chassis

System-on-Module (SOM) PCA

The System-on-Module (SOM) PCA memory stores the device software and configuration data. When
you install a new SOM PCA, you must also:
Enter the device's serial number and enable options using the Service Mode menus.
Install the most recent software in the appropriate language using the Software Support tool. See
Table 35
Give the user the README document that contains instructions for downloading the most recent
Efficia DFM100 Instructions for Use from the Philips' Documentation and Download web site
(
http://www.philips.com/ProductDocs
You need a T-8 screwdriver to detach or attach the SOM PCA.
Preparation
Save the customer's configuration settings to a USB flash drive so the configuration can be restored
1
after the repair is complete. See the Efficia DFM100 Instructions for Use for information.
Open the Case. See
2
Remove the Measurement Module. See
3
4
Remove the Therapy Port. See
5
Remove the Printer Assembly. See
6
Remove the Main Chassis. See
7
Remove the Main PCA Module of the Main Chassis. See
page 115.
Removal
Loosen and remove the two T-8 screws. See
1
Hold the two shorter sides of the SOM PCA next to the screw holes.
2
Using equal force on each side, gently detach the SOM PCA from the Processor PCA.
3
Do not wiggle or twist the SOM PCA to avoid excessive stress on the connectors between the SOM
PCA and Processor PCA.
Figure 98
Replacement
There is a key-in feature on the rectangular connectors. Align the key-in during installation, see
1
Figure
on page 178 for part numbers.
"Opening the Case"
"Therapy Port"
"Separating Main Chassis and Rear Case"
SOM PCA Removal
99.
).
on page 90.
"Measurement Module"
on page 109.
"Printer Assembly"
on page 111.
"Disassembling Main Chassis"
Figure
98.
4: Repair
on page 107.
on page 113.
on
123

Advertisement

Table of Contents

   Also See for Philips Efficia DFM100

Comments to this Manuals

Symbols: 0
Latest comments: