Download  Print this page

Spo 2 Desat Alarm - Philips Efficia DFM100 Instructions For Use Manual

Defibrillator/monitor.
Hide thumbs

Advertisement

10: Monitoring SpO
2
Table 25
Alarm Message













NOTES: SpO
alarms are on in all clinical modes (except AED and Manual) unless you specifically turn them
2
off or alarms for the entire device are off. Once disabled, alarms remain off until they are turned back
on.
While an NBP measurement is in progress, SpO
SpO
Desat Alarm
2
The SpO
of potentially life-threatening decreases in oxygen saturation. This additional limit is preset through
Configuration Mode.
NOTE: If the SpO
automatically adjusted to the SpO
the SpO
114
SpO
Technical Alarms
2
The device is unable to detect a
Pleth waveform due to a SpO
sensor malfunction.
The SpO
2
A noisy SpO
been detected.
Light interference has been
detected at the SpO
A non-pulsatile SpO
been detected.
A problem with the SpO
module has been detected.
An erratic measurement has been
detected.
The SpO
2
been updated within the last 30
seconds.
The device has detected low
perfusion.
A non-critical failure has been
detected.
Desat alarm provides an additional limit setting below the low limit setting to notify you
2
Low Limit alarm value is set below the configured SpO
2
Desat Limit Alarm is announced.
2
Condition
2
sensor is disconnected.
sensor signal has
2
sensor.
2
signal has
2
Low Priority
Non-Latching
2
Alarm
measurement has not
alarms are suppressed.
2
Low Limit value. Should the SpO
2
Type of Alarm
Indication
Cyan alarm message
with audio tone
Desat Limit, the Desat Limit is
2
reading fall below this value,
2
SpO
Alarms
2

Advertisement

Table of Contents

   Also See for Philips Efficia DFM100

   Related Manuals for Philips Efficia DFM100

Comments to this Manuals

Symbols: 0
Latest comments: