Basic Operation; Siem-2T - JTS SIEM-2T User Manual

6.

Basic Operation

6-1 SIEM-2T

1. Power On / Off
Turn on or turn off the transmitter by pressing
the "POWER" button.
2. Volume
Adjust the volume to a proper level.
VOLUME
13
POWER
SIEM-2T
Transmitter
POWER
POWER
SIEM-2T
Transmitter
3. Setting
LED Display
1 Channel LED Display
2 Channel Selector
Select Channel
Hold "Channel Selector" for about 3 seconds, the decimal
point in LED Display starts flashing, allowing you to
change the channel. Then, cycling press "Channel
Selector" to select a desired channel from preset 16
channels. (0-9,A-F)
1
CHANNEL
Notice.1 : The channel of the transmitter must match
that of the receiver .
Notice.2 : The LED Display will stop flashing if no
operation for about 6 seconds
2
SET
14