[Info]: Display picture information.
[Rotate +90]: Rotate the picture 90
[Rotate -90]: Rotate the picture 90
[Zoom]: Zoom into a video scene or
picture. Press the Navigation buttons
(left/right) to select a zoom factor.
[Duration per slide]: Select the display
speed for each picture in a slide show.
[Slide animation]: Select animation for
the slide show.
[Picture settings]: Select a predefined
[Repeat]: Repeat a selected folder.
If the picture and audio files are from the same
disc or USB storage device, you can create a
Select an audio track, and then press OK.
, and go to the picture folder.
Select a picture, and then press
to stop slideshow.
again to stop music.
Make sure that the picture and audio formats are
supported by your SoundStage (see 'USB' on page 33).
Listen to FM radio on your SoundStage, and
store up to 40 radio stations.
AM and digital radio are not supported.
If no stereo signal is detected, you are prompted to
install the radio stations again.
Connect the FM antenna to FM
ANTENNA on your SoundStage.
For the best reception, place the
antenna away from your TV or other
sources of radiation.
Press SOURCE repeatedly to select radio
" If you have already installed the radio
stations, the last channel that you
listened to is played.
" If you have not installed any radio
stations, the message [AUTO
INSTALL...PRESS PLAY] appears on
the display panel. Press
Use the remote control to select or to
change radio stations.
Select a preset radio station.
Left/Right: Search for a radio
Up/Down: Fine tune a radio
Press to stop the installation
of radio stations.
Press and hold to erase the
preset radio station.
Manual: 1) Press
. 2) Press
to select your preset.
again to store the
Automatic: Press and hold for
three seconds to reinstall the
Toggle between the stereo
and mono sounds.
12/10/2013 6:04:00 PM