Technical Data - AEG AGE62526NX User Manual

Problem
Temperature cannot be set. The FROSTMATIC or
DEMO appears on the dis-
play.
The temperature in the ap-
pliance is too low/too high.
Side panels of the appli-
ance are warm.
Door does not open easily.
If the advice does not lead
to the desired result, contact
the nearest Authorised
Service Centre.
7.2 Replacing the lamp
The appliance is equipped with a longlife
LED interior light.

8. TECHNICAL DATA

Height
Width
Depth
Possible cause
COOLMATIC function is
switched on.
The appliance is in demon-
stration mode.
The temperature regulator
is not set correctly.
The food products temper-
ature is too high.
The FROSTMATIC function
is switched on.
This is a normal state
caused by operation of the
heat exchanger.
You attempted to re-open
the door immediately after
closing.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
1850 mm Rising time
595 mm Voltage
668 mm Frequency
ENGLISH
Solution
Switch off FROSTMATIC or
COOLMATIC manually, or wait
until the function resets auto-
matically to set the tempera-
ture. Refer to "FROSTMATIC
or COOLMATIC function".
Keep the OK pressed for ap-
proximately 10 seconds until a
long sound is heard and dis-
play shuts off for a short time.
Set a higher/lower tempera-
ture.
Let the food products temper-
ature decrease to room tem-
perature before storage.
Refer to "FROSTMATIC func-
tion".
Make sure that there is at least
30 mm of space between each
side of the appliance and the
surrounding furniture when
the ambient temperature ex-
ceeds 38°C.
Wait a few seconds between
closing and re-opening of the
door.
28 h
230 - 240 V
50 Hz
23