Sony MHC-V72D Operating Instructions Manual page 35

If your device is an NFC-compatible
BLUETOOTH device, the manual
pairing procedure is not necessary.
(See "One Touch BLUETOOTH
Connection by NFC" (page 37).)
1
Place the BLUETOOTH device
within 1 meter from the unit.
2
Touch FUNCTION on the unit
repeatedly to select
"BLUETOOTH".
Note
When there is no pairing information
• •
on the system (for example, when
you use the BLUETOOTH function
for the first time after purchase),
"PAIRING" flashes on the display and
the system enters the pairing mode.
Proceed to step 4.
If the system is connected to
• •
a BLUETOOTH device, touch
BLUETOOTH on the unit to
disconnect the BLUETOOTH device.
3
Touch and hold
the unit for 3 seconds or more.
"PAIRING" flashes on the display.
4
Turn on the BLUETOOTH
function on the BLUETOOTH
device and perform the pairing
procedure.
For details, refer to the operating
instructions of your BLUETOOTH
device.
5
Select the system's name (for
example, "MHC-V82D") on the
display of the BLUETOOTH
device.
Perform this step within 5 minutes,
otherwise pairing will be canceled.
In this case, repeat from step 3.
PAIRING on
Note
If passkey is required on the
BLUETOOTH device, enter "0000".
"Passkey" may be called "Passcode",
"PIN code", "PIN number", or
"Password".
6
Establish connection with the
BLUETOOTH device.
When pairing is completed and the
BLUETOOTH connection is
established, BLUETOOTH device
name appears on the display.
Depending on the BLUETOOTH
device, connection may start
automatically after pairing is
completed.
You can check the BLUETOOTH
device address by pressing DISPLAY
repeatedly.
Note
You can pair up to 8 BLUETOOTH devices.
If the 9th BLUETOOTH device is paired, the
oldest paired device will be deleted.
To cancel the pairing operation
Touch and hold PAIRING on the
unit for 3 seconds or more until "BT
AUDIO" appears on the display.
To erase pairing information
You can erase all pairing information
by resetting the system. See
"Resetting the system" (page 69).
Note
After you reset the system, it may not be
able to connect with your iPhone/iPod. In
this case, delete the pairing information
of the system on your iPhone/iPod, then
perform the pairing operation again.
35
GB