Mitsubishi Electric JT-SB116EH-W-CA Handbook page 7

4-2 How to use the hand dryer
Power controll section
H e a t e r
O N
I
O F F
O
e e d
A ir s p
Swicth
P o w e r
door
O N
I
O F F
O
Display
Emblem
With the power switch OFF
Power Heater Check
Check lamp
Power lamp
Heater lamp
In case of trouble or error
Power Heater Check
Check lamp
Power lamp
Heater lamp
1
With both hands open, insert them
all the way in
The unit will come on automatically.
Heater
switch
Air
speed
knob
Power
switch
Power lamp
Heater lamp
Check lamp
I When not using the unit for long periods of time
Turn the power switch off.
The unit consumes approximately 2W of power even if unused when the power is on.
(With the heater switch "OFF")
* When the heater switch is turned "ON", approx. 1100 W of power is
consumed to accumulate heat by operating the heater.
I Check lamp
When a malfunction or error occurs, the check lamp on the right side of the display will
either light up or flash. Turn the power switch off, wait approximately 30 seconds until the
all the lamps in the display go off, and then turn the power back on. If the check lamp is
still on or flashing, turn off the power, shut off the ground-fault circuit interrupter, and
refer to "10.Troubleshooting (page19)".
2
Pull them out slowly,
letting the air blow the
water off.
Repeat until dry
N
Introduction
1.
Open the switch door of the power controll section.
2. Turn on the power switch.
G
Power lamp and heater lamp turn on. (Display)
G
Emblem lamp turns on.
G
Illumination lamp turns on.
G
Adjust the Air speed knob to the best point.
Note:
G When the power switch is turned on, make sure to remove
hands from the hand-drying area. Take sufficient care to
avoid this because it may deteriorate the sensitivity of sensor.
3.Close the switch door of the power controll section.
Display
With the heater switch ON
Power Heater Check
Check lamp
Power lamp
Heater lamp
— 7 —
With the heater switch OFF
Power Heater Check
Check lamp
Power lamp
Heater lamp
3
Pull hands all the way
out.