Summary of Contents for Sinclair Manual Grommet Machine PG20
Page 1
Model PG-20 Manual Grommet Machine Operating Manual (800) 624-2408 (530) 626-9386 Fax (530) 626-5144 6686 Merchandise Way Diamond Springs, Ca 95619 www.sineqco.com...
Page 2
Please read this instruction manual carefully for your guidance, in order to make the most of your machine. Always use extreme caution when operating machine. Keep hands free of cutting surfaces. SINCLAIR EQUIPMENT DECLINES ALL RESPONSABILITY ON THE INCORRECT USE Grommet 8mm Plastic Grommet...
Page 3
Installation of PG-20 Install grommet machine on secure table top with the front of machine base flush with table edge. Use four bolts with lock nuts/washers to secure machine. Adjusting both the cutting and the grommet pressure. ALWAYS ADJUST FIRST THE CUTTING PRESSURE, NEVER TRY DO CUTTING AND SETTING AT THE SAME TIME.
Page 4
In order to adjust the grommet pressure. Insert grommet on die #3 as shown in figure 1 below. Make sure bottom of grommet is up above bottom of top die. No washer is needed for 8mm grommets. For 12mm grommets, insert washer on die #4 as shown in figure 2.
Page 5
Change Of Dies The PG-20 will take two die sets. If you want to change out sizes, you will need to replace parts. Please refer to the following diagrams. 8mm Die Set 12mm Die Set Only used in 12mm die set.