Performing A Blood Glucose Test - GE GE006 Manual

Performing a Blood Glucose Test

1. Hold the depth adjustable cap in one hand and hold the base
with the other hand. Bend the cap down. When a gap
appears between the cap and base, pull the cap and base in
opposite directions.
2. Pull off the depth adjustable cap.
3. Insert a new disposable lancet firmly into lancet carrier.
4. Twist off and set aside the protective cover of the disposable
lancet.
5. Replace the depth adjustable cap.
6. Choose a depth of penetration by rotating the top portion of
the depth adjustable cap until your desired setting is visible
in the window. Settings are based on skin type "
soft or thin skin; " " for average skin; "
calloused skin.
26
1
2
3 4
5 6
" for
" for thick or
7. Hold the base in one hand and pull on the plunger with the
other hand. The device will be cocked. Release the plunger
and it will automatically move back to its original position
near the base.
8. Wash your hands with warm soapy water and dry
thoroughly.
9. Take one GE006 Blood Glucose Test Strip from the vial.
Close the vial cap immediately.
10. Insert the strip into the test strip port of the GE006 Blood
Glucose Meter with the view window facing up.
11. Once the strip is inserted, all symbols will appear on your
meter display and will be accompanied by a beep (if
volume is turned on).
NOTE
- The GE006 Blood Glucose Meter will automatically detect the Code
number on the strip. You do not have to check the Code number on
the meter display and strip vial.
Performing a Blood Glucose Test
7
8
9 10
11
27