Safety Precautions - Panasonic MINAS-BL GP series Technical Instructions

Safety Precautions

The following explanations are for things that must be observed in order to
prevent harm to people and damage to property.
• Misuses that could result in harm or damage are shown as follows, classified
according to the degree of potential harm or damage.
Danger
Indicates great possibility of death or serious
injury.
Caution
Indicates the possibility of injury or property
damage.
• The following indications show things that must be observed.
Indicates something that must not be done.
Indicates something that must be done.
Do not touch the rotating part of the motor
while operating.
The failure could result in injuries.
Do not expose the cables to sharp objects,
excessive pressing or pinching forces, and
heavy loads.
The failure could result in electric
shocks, damages, or malfunction.
Do not climb or stand on the brushless
equipment.
The failure could result in electric shocks,
injuries, damages, or malfunction.
Do not place inflammable matter near the motor,
amplifier and external regenerative resistor.
The failure could result in fire.
Important
DANGER
Do not touch the motor, amplifier, and external
regenerative resistor, since they become hot.
The failure could result in burns.
Do not subject the product to water, corrosive
or flammable gases, and combustibles.
The failure could result in fire.
Do not put your hands in the brushless
amplifier.
The failure could result in burns,
or electric shocks.
Do not connect the cable (U, V and W) of the
brushless motor directly to the commercial
power source.
The failure could result
in fire, malfunction or damage.
－ 2 －
Ground the earth of the brushless motor and
brushless amplifier.
The failure could result
in electric shocks.
Install an external emergency stop device
to shut down the main power source in any
emergency.
The failure could result in electric shocks,
injuries, fire, damages or malfunction.
Make sure to secure the safety after the
earthquake.
The failure could result
in electric shocks, injuries, or fire.
Mount the brushless motor, brushless
amplifier and external regenerative resistor on
incombustible material such as metal.
The failure could result
in electric shocks, injuries, or fire.
Arrange the phase sequense of the motor and
wiring of the CS sensor.
The failure could result
in injuries, damages, or malfunction.
CAUTION
Do not approach to the equipment after
recovery from the power failure because they
may restart suddenly.
The failure could result in injuries.
Do not hold the cables or motor shaft when
transporting the motor.
The failure could result in injuries.
An over-current protection, earth leakage
breaker, over temperature protecter and
emergency stop device must be installed.
The failure could result
in electric shocks, injuries, or fire.
Install the product properly to avoid personal
accidents or fire in case of an earthquake.
The failure could result
in electric shocks, injuries, or fire.
Only persons who are trained and qualified
to work with or on electrical equipment are
permitted to operate or maintain this equipment.
The failure could result
in electric shocks.
Transportation, wiring and checking must
be performed with power source turned off
and after making sure that there is no risk of
electric shock.
The failure could result
in electric shocks or injuries.
Do not drive the motor from the external power.
The failure could result in fire.
Never start and stop the motor by magnet
contactor which is provide on the main line.
The failure could result in damages.
－ 3 －