Taking Pictures Using The Flash (Supplied) - Panasonic Lumix DC-LX100M2 Basic Owner's Manual

Taking pictures using the flash (supplied)

Applicable modes:
This section describes how to take a picture using the flash (supplied).
For details about how to attach external flashes other than the supplied flash, refer
to their operating instructions.
Attaching the flash
∫ Removing the Hot Shoe Cover
The camera comes with a hot shoe cover attached to the hot shoe.
Remove the hot shoe cover by pulling it in
the direction indicated by arrow 2 while
pressing it in the direction indicated by
arrow 1 .
• Be sure to attach the hot shoe cover when the hot shoe is
not in use.
• Keep the hot shoe cover safely after removing it so that
you do not lose it.
• Keep the hot shoe cover out of reach of children to prevent swallowing.
∫ Attaching the flash
1
Turn off the camera and the flash.
2
Firmly insert the flash into the hot shoe of this
unit until it clicks. (A)
• When recording, set the on/off switches of the
camera and flash to [ON].
• Do not hold the flash to carry the camera when the
flash is attached to the camera.
A Hot shoe
B Flash [ON/OFF] switch
C Lock release button
∫ Removing the flash
1
Turn off the camera and the flash.
2
Press and hold the lock release button and pull
the flash in the direction indicated by the arrow to detach the flash. (B)
• When detaching the flash, do so slowly and carefully.
• Attach the hot shoe cover to the hot shoe of the camera.
• Store the detached flash in its soft case.
Recording

 
 
(ENG) DVQX1572
 
47