External Device Configuration
Set the method and protocol used for communicating with external devices.
Setting procedure
The procedure for setting the external device to be connected is shown below.
1.
Select the external device to be connected in "Module List" and drag it to "List of devices" or "Device map area".
2.
Set the required items. The required items vary depending on the selected external device.
3.
Select [Close with Reflecting the Setting] to finish the external device configuration settings.
External devices must be set from the connection No.1
To use specific connection number, set "MELSOFT Connection Module" in the connection number not used.
• When only the connection No.5 is used.
2 PARAMETER SETTINGS
244
2.2 Basic Settings