Simplicity 319 Specifications

POWER STAKE-OFF
For operation of Rotary Mower and Sickle Bar attach-
consists of the power take-off assembly, "V"
for bevel gear shaft, drive belt, belt guard, and belt
For ease of attachment follow the step; outlined
below.
1. Mount pulley to shaft
screw.
of pulley is to face inward.
Hub
drive belt on pulley and mount belt guard support to.:
inside surface of side plate nearest drive pulley. See'
figure 5 for mounting bolt location.
guard to the guard support as shown in figure 1.
approximately 3/16" clearance between
B E L T G U A R D S U P P O R T
F i g .
2. Holding the power take-off assembly in left hand
as shown in fieure 2. oosition the tube of the drive
bracket assembly b&&n
side plates. Align the holes in side plates with the
hole in drive bracket assembly tube and insert
pivot pin through holes in side plates and drive
bracket assembly tube.
3. Push pivot pin through the holes in bracket and
tube until the position of cotter pin hole in pivot
pin is as shown in figure 3. Secure in position with
cotter pin furnished.
pulley
of bevel gear assemble
Attach the ~belt.
Allow
and hard;:
belt
I
the bevel gear housing
LANDLORD RIDING TRACTOR
EVEL GEAR HOUSING SIDE PlqT'
B
4. Remove hex cap screw "D" from frame oftractor
and bracket in place under lift lever quadrant.
See figure 4. Position the pivot bar assembly flush
against bottom of lift quadrant and re-install hex
cap screw and tighten,securely.' Check alignment of
drive pulley on bevel gear shaft, driven pulley of
power takg-off, and idler pulley, and adjust driving
p u l l e y i f n e c e s s a r y . ~,
S I D E P L A T E