Connecting; Wiring And Block Diagram - Siemens SIMATIC ET 200SP Manual

Connecting

3.1

Wiring and block diagram

This section includes the block diagram of the DQ 16×24VDC/0.5A ST module with the
terminal assignments for a 1-wire connection.
You can find information on wiring the BaseUnit in the system manual Distributed I/O System
ET 200SP (http://support.automation.siemens.com/WW/view/en/58649293).
Note
The load group of the module must begin with a light-colored BaseUnit. Keep this in mind
also during the configuration.
Note
The fuse integrated in BaseUnit type A1 may be triggered in the digital output module,
rendering the terminals unusable.
Make sure that you only use digital output modules with BaseUnit type A0 during
commissioning.
14
Digital output module DQ 16x24VDC/0.5A ST (6ES7132-6BH01-0BA0)
3
Manual, 09/2017, A5E03574420-AE