Setup Guide - Furuno NX-700B Service Manual

3. Setup Guide

Configure the setting according to the needs of each user.
This NX-700A/B receives NAVTEX messages in the default setting as it is. Basically,
the NAVTEX, System, Display and Service menus are to be set by users. Do not attempt
to change the settings of the Initialize1 and Initialize2 menus needlessly.
If they have to be changed, do it after understanding the functions of them.
Menu Item
Mask Mode
Auto Rcv Mask
Local Channel
NAVTEX
Rcv Mask
Ver-02.01
INS Output
Mask
Printer Mask
Receiver Mode
Local Channel
NAVTEX
Auto Print
Ver-01.02
Rcv Station &
Msg
User Select
Station & Msg
Warn Msg Alm
System
Signal Monitor
Cont'd
Key Beep
Time Offset
Cont'd
Setting
INS Select "INS" to set the Rcv Mask by
sentences from the INS.
Manul
Off Normally ON
Setting to enable the Auto mode
On
490kHz
Selection of receiving frequency
4209.5kHz
Station : A-Z Setting of stations and message types.
Message: A-Z The default setting is "Select All".
The default setting is "Select All".
Station : A-Z
Selection of stations and messages to be
Message: A-Z
outputted to the INS.
Station : A-Z
Setting of printer output
Message: A-Z
INS Normally "Auto"
When "Auto" is selected, the Auto mode is
Auto
enabled.
Manul
490kHz
Selection of receiving frequency
4209.5kHz
Off
Setting of printer output when a message is
All
received.
User Select
Station : A-Z Setting of stations and message types.
Message: A-Z The default setting is "Select All".
Setting of sorting items of station and
Station : A-Z
message type in "User Select Message" on
Message: A-Z
the [LIST] menu.
Setting of ON/OFF of alarm beep
Off
when a message A, B or L is received.
On
Off
Selection of the frequency to be monitored.
Int'l
Local
Off
ON/OFF of Key beep setting
On
Time difference of time display setting
+ 00:00
2-2
Table 2.2 User Setup Guide
Remarks
Overview
Page
2-8
2-9
2-10
2-10
2-11
2-12
2-13
2-14
2-14
2-15
2-15
2-16
2-17
2-17
2-18