Connection Of Calibration Winding With Dssiu-6-1U (-V) - Danisense DS Series Product Manual

DSSIU-4-1U
DSSIU-6-1U
DSSIU-6-1U-V
1. Mains voltage
2. DSUB9 connector for transducer connection
3. Banana jacks for transducer's current output
4. Banana jacks for calibration winding terminals
5. Status connector
6. Mini XLR socket for transducer's voltage or current outputs
2.3.3.3 Connection of calibration winding with DSSIU-6-1U (or DSSIU-6-1U-V)
When a device with calibration winding type - CD[n turns] is connected to the DSSIU-6-1U using the
optional DSUB cable, the terminals of the calibration winding are accessible via the yellow banana sockets
at the back panel of the DSSIU-6-1U (or DSSIU-6-1U-V). It's very convenient to carry out a simultaneous
calibration of 6 devices connected in serial (illustration below).
+
-
Calibration windings
I calibration
2
3
2 3
6
2
9
1
4 5
1
5 1
4
DSUB cable