Download Print this page

ACR Electronics Satellite3 406 RLB-38 Product Support Manual page 22

406 mhz epirb beacon

Advertisement

Always refer battery replacement and any other beacon service to a factory
authorized
http://www.acrelectronics.com/brc.htm.
servicing the beacon by replacing all o-rings, testing the water seal and the
electrical properties and doing a full functional test on the unit.
NOTE: There are no user serviceable items inside the beacon. Do not open
the beacon except to disable (in case of faulty or accidental activation).
Otherwise, always have the beacon serviced.
WARNING: Battery contains lithium
To avoid possible fire, explosion, leakage or burn hazard, do not open,
recharge, disassemble or heat beacon above +70º C (+158º F) or
incinerate.
These products contain lithium in the battery. Various beacons may or may
not require special shipping instructions due to the lithium batteries and
changes in shipping regulations. Shipping of hazardous materials requires
special
handling
shipping
information,
http://www.acrelectronics.com/hazmat/default.htm.
In the case of the RLB-38, the product contains small batteries that are non-
hazardous. However, regulations can change. Be advised that it is best to
verify the shipping requirements at the time you are preparing to ship the
unit.
4.
Shore based maintenance for SOLAS vessels, (SBM) IMO
MSC/Circ. 1039
The Maritime Safety Committee has approved guidelines for shore-based
maintenance of satellite beacons, for the purpose of establishing
standardized procedures and minimum levels of service for the testing and
maintenance of satellite beacons. The first shore based maintenance on all
ACR EPIRBs is due at the date of the first battery replacement. Visit ACR's
website at
www.acrelectronics.com
based maintenance.
5.
Annual testing for SOLAS vessels, IMO MSC/Circ. 1040
SOLAS regulation IV/15.9 dictates annual testing of 406 MHz satellite
EPIRBs. Testing should be carried out using suitable test equipment
capable of performing the relevant measurements. All checks of electrical
parameters should be performed in the self-test mode, if possible. These
tests can be performed by certified ACR Battery Replacement Centers
(BRCs). Visit ACR's website at
BRCs.
Y1-03-0250 Rev. B
Service
Center.
and
documentation.
can
Find
a
Battery
MSDS
be
found
for organizations that perform shore
www.acrelectronics.com
Center
near
replacement
sheets,
along
on
our
website
for authorized ACR
you
at
includes
with
at
21

Advertisement

loading

This manual is also suitable for:

Satellite3 406 y1-03-0250Sat3Rlb-38 2874Rlb-38 2875