Replacing The Printhead Holder - CAB EOS Series Service Manual

2 Replacing Assembly Units
2.8

Replacing the Printhead Holder

Fig. 9 Removing / mounting printhead holder
Removing
 Remove the casing.
 Remove the printhead.
 Remove the spring (2) from the spring bolt (1).
 Lift the printhead holder (7), unlock the latch (4) and push the printhead holder with the spring (2) to the operator's
side out of the chassis (3).
 Remove the printhead holder (7) with the spring (2) completely from the retainer (6). In doing so remove the
printhead cable (8) from the printhead holder.
 Keep the spring (2).
Mounting
 Push the printhead holder (7) onto the retainer (6). In doing so insert the printhead cable (8) into the printhead
holder.
 Push latch (4) and spring hook (5) of the printhead holder through the gap of the chassis (3).
i
Note!
For the following mounting of the spring (2) it is recommended to push the printhead holder in a position,
where the latch (4) is clamped by the chassis but not completely locked yet.
 Mount the spring (2) onto the spring hook (5).
 Push the printhead holder (7) further until the latch (4) clicks into place.
 Mount the spring (2) onto spring bolt (1).
 Mount the printhead.
 Mount the casing.
1
2
3
4
5
3 5 4 6 7 8
13