Troubleshooting - Silvercrest STG 85 A1 Operating Instructions Manual

Tabletop freezer

Hide thumbs Also See for STG 85 A1:

Operating instructions manual (29 pages)

Table Of Contents

Table of Contents

Enlarged version

2. Lean the appliance back a little and secure it so

that it is safe. Completely unscrew and remove

the front adjustable feet. Before you commence

the next step, make preparations to prevent the

appliance door from falling down. Remove the

screws holding the lower door hinge and take

the hinge off (Fig. 2). Replace the screws back

into the holes on the freezer.

Fig. 2

3. Now lay the door to the side.

4. Unscrew the nut of the lower door hinge off and

remove the axle. Fit the axle on the other side.

Now rescrew the nut tightly firmly back on the

axle (Fig. 3).

Fig. 3

5. You now have to reassemble the components on

the opposite side. For this, unscrew the screws from

the pre-drilled holes and screw the door hinge

back on. Replace the adjustable feet. The adjust-

able foot with the long screwed thread must be

located on the side where the door hinges are

fixed. Bring the appliance back into the horizontal.

6. Unscrew the axle of the upper door hinge. Turn the

hinge around through 180 ° on its longitudinal

axis and rescrew the axle back in (Fig. 4).

Fig. 4

7. Remove the white cap on the door bottom that

covers the hole for the axis of the hinge. Replace

the white cap in the now no longer needed hole.

8. Now position the door on the axis of the lower

hinge. Remove the screws for the top hinge from

the holes on the opposite side of the freezer and

screw the top hinge back on with the help of these

screws, b b u u t t n n o o t t y y e e t t f f i i r r m m l l y y . .

9. Now check the horizontal and vertical alignment

of the door. Ensure that the sealing of the door

sits firmly against its counterpart on the housing.

First then do you secure all screws hand tight.

10.Now replace the upper appliance cover and

screw it down tightly using the corresponding

screws. Refit the temperature controller on the

axle so that it is firmly seated.