Beating Cream - Silvercrest SMZ 260 B1 Operating Instructions Manual

Risk of personal injury!
Never attempt to remove food from the bowl 6
when the blade 7 is still in motion. Contents could
shoot out and make a mess.
➩
Wait until the blade 7 has stopped rotating.
➩
Lift the motor block 2 from the lid collar 3.
➩
Remove the lid 4.
Risk of personal injury!
To avoid injuries, exercise caution when handling
the extremely sharp blade 7. Keep the blade 7
out of the reach of children.
➩
Carefully pull the blade holder 5 with the knife
7 out of the bowl 6.
➩
Remove the contents.
Note
Due to the grinding of hard and abrasive foodstuffs,
the bowl 6 can take on a dull appearance over
time. This is normal and does not influence the
functioning of the appliance.
Tip
After you have finished processing the foodstuffs,
you can use the appliance base
the bowl , this will help to keep the foodstuff fresh
y
for longer.
➩
Remove the motor block 2 and the lid 4 from
the bowl .
y
The blade retainer 5 with the blade 7 can, if
you wish, remain in the bowl
➩
Loosen the appliance base
de of the bowl . You can now place applian-
y
ce base on the bowl
o
bowl y .
o as a cover for
y .
from the undersi-
o
so that it seals the
y

Beating cream

Using the whisk attachment 0, you can also whip
cream with this appliance:
➩
Place the bowl 6 in the appliance base 9.
➩
Place the blade holder 5 with the knife 7 on
the mounting 8.
➩
Push the whisk attachment 0 onto the blade hol-
der 5:
For 100ml of cream, place it on the blade holder
so that the whisk attachment 0 rests on the two
blades and engages.
For 200ml of cream, turn the whisk attachment
0 vertically through 180°, so that it rests on
only one blade and engages. It then ploughs
higher through the cream:
➩
Pour the cream in.
➩
Close the bowl 6 with the lid 4: Place it on the
bowl 6 so that the lugs on the lid 4 engage in
the slots on the bowl 6. Then turn the lid 4 so
that the lugs slide unter the slots and the lid 4
locks into place.
➩
Place the motor block 2 on the lid collar 3.
➩
Press the motor block 2 downwards , as shown
in Figure B. The motor starts with the normal ope-
rating speed.
- 5 -