Maintenance - Husqvarna 530iP4 Operator's Manual

• Use the stop at the base of the cutting head to
provide support during cutting. This will help prevent
the cutting attachment from "jumping" on the branch.
• Make an initial cut on the underside of the branch
before cutting through the branch. This will prevent
tearing of the bark, which could lead to slow healing
and cause permanent damage to the tree. The cut
should not be deeper than 1/3 of the branch
thickness to prevent jamming. Keep the chain
running while you withdraw the cutting attachment
from the branch to prevent it jamming.
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance work on
the product.
WARNING: Remove the battery before you
do maintenance on the product.

Maintenance

Clean the external parts of the product with a
dry cloth. Do not use water.
Make sure that the start and stop button
works correctly and are not damaged.
Make sure that the power trigger and the
power trigger lockout function correctly from
a safety point of view.
Make sure that all controls work and are not
damaged.
Keep the handles dry and clean. Makes sure
that that there is no oil and grease on the
handles.
14
• Make sure you have a firm footing and that you can
work without being hampered by branches, stones
and trees.
Maintenance
Maintenance schedule
The following is a list of the maintenance steps that you
must do on the product. Refer to the tasks in the
maintenance chapter for more information.
Daily
X
X
X
X
X
WARNING: Never activate the power
trigger without having the cutting
attachment in full view.
WARNING: Remove the battery before you
do maintenance.
Weekly
783 - 001 - 12.11.2018
Monthly