JB Systems PIXEL PIPE Operation Manual page 10

ENGLISH
C. Controlled by the wireless remote controller:
To be able to use the wireless remote control, you need to enable this option in the projector:
• Press the [MODE] button until [Iron] or [IroF] is shown on the display.
• Use the ▼ and ▲ buttons to enable or to disable the remote control option ([Iron] = remote control
enabled, [IroF] = remote control disabled).
Functions:
1. [AUTO RUN]-button (A): used to start the build in programs in automatic mode.
2. [BLACKOUT]-button: used to switch the output ON/OFF
3. [FLASH]-button (F): used to switch the strobe function ON/OFF. First press the F-button, followed by
the ±buttons (6) to adjust the strobe speed.
4. [SOUND ACTIVE]-button (S): used to start the sound activated programs. With the ±buttons (6) you
can adjust the sensitivity.
5. [DIMMING]-buttons (RGB): press one of these buttons
to select the static custom color and adjust one of its color
components:
• Press the R-button: then use the ±buttons (6) to
adjust the red component in the custom color.
• Press the G-button: then use the ±buttons (6) to
adjust the green component in the custom color.
• Press the B-button: then use the ±buttons (6) to
adjust the blue component in the custom color.
6. ±-Buttons: used to increase / decrease the value of the
selected function.
7. Number buttons (0-9): used to set the DMX-address.
8. [SPEED]-button (SP): used to change the running speed
of the build in programs.
9. [SELECT PROG]-button [(PROG)]: used to select one of
the effect program modes. With each press you go to the
next effect:
• Fixed colors (CL00-CL07)
• Build in programs (PR01-PR20). The speed of these
programs can be adjusted.
10. [DMX MODE]-button (D): used to set the desired DMX
address and channel mode (3, 7 or 24 channels)
11. [SET ADDR]-button (S): used to enter the value of the
desired DMX-address.
12. [SLAVE]-button (SL): used to put the fixture in slave
mode.
13. Battery compartment: receives a CR2025 3V-battery
(supplied).
D. Controlled by a universal DMX-controller:
• Connect all units together. Refer to the chapter "Electrical installation for two or more units in DMX-
mode" to learn how to do this (don't forget to address all units properly!)
• Connect all units to the mains and turn on the DMX controller.
Since each unit has its own DMX-address, you can control them individually. Remember that each unit
uses 3, 7 or 24 DMX-channels, depending on the DMX-mode you have selected in the menu. See the
different DMX charts below:
JB SYSTEMS
®
8/11
USER MANUAL
PIXEL PIPE