No Spinning; Too Much Spinning Noise - Haier LMA9020WGAB0 Service Manual

Service Manual Service Manual
Model No:MABE500-1789

6-2-6 No spinning

6-2-7 Too much spinning noise

The washing and
draining are normal.
Check the On/off point of the
microswitch and stop switch.
Normally
Check if the clutch pawl
is pulled enough.
Yes
Replace the retarder clutch.
If the washing machine
is set horizontally?
No
If the hanger is
wrongly used?
No
If the noise of the motor
is too much?
No
If the motor is fastened
tightly?
Yes
If the bearing of the retarder
is well?
Yes
If the departing of
the ratchet and pawl
is well?
No
If the machine body
vibrate resonantly with th
cabinet?
No
If the balance ring is rubbing
the outer tub cover?
No
If the connecting pipe
or the wire unit bumps
the outer tub?
No
The hanger seat is lack of oil.
Inject oil at the hanger seat.
No On/Off point
No
Replace the drain motor.
At this time please check
if the drain motor is well.
Yes
Set the machine horizontally
Yes
Replace the hanger.
Yes
Replace the motor.
No
Fasten the motor.
No
Replace the retarder.
Adjust the angle or the distance of
Yes
the ratchet and pawl. The distance
between the ratchet and the pawl is
above 2mm.
Yes
Adjust the cabinet to acquire
balance.
Yes
Adjust the gap between the
balance ring and the outer tub.
Yes
Fix the connecting pipe and
wire unit.
20
Issue
Rev.
Replace the microswitch
or stop switch.