During The Conference - Siemens OptiPoint 410 Operating Instructions Manual

Step by Step
>
View members?
No. member No.
Next conference party? >
Next conference party? >
>
Stop viewing?
>
Release party?
>
Remove last party?
Line
>
Hold?
Line

During the conference

You are taking part in a conference with 3 to 8 members
and you wish to know about the other members or to
disconnect a member.
Viewing member information
:
Select and confirm.
>
1
The display shows the name and call number of the oth-
er member with lowest member number.
:
Confirm to display the next member.
or
:
Select and confirm to end the display.
>
or
:
Select and confirm to disconnect this member from the
>
conference. If there were only three members, the con-
ference is now ended and the call continues as a two-
party call.
Disconnecting the last member added
You wish to disconnect the last member added to the
conference.
:
Select and confirm. The last member added is discon-
>
nected. If there were only three members, the confer-
ence is now ended.
Putting the conference on hold
If line keys are installed
ference on hold and make a call on another line.
Press line key.
or
:
Select and confirm.
The conference will be put on hold. The following mes-
sage is displayed: 1st line: "Conference", 2nd line: "On
hold".
Press the line key on which the conference is being held
- you are reconnected to the conference.
Making Calls – Convenience Functions
page 75 you can put the con-
45