Restoring The Handset Default Settings; Base Station Settings; Restoring The Base Station To Factory Settings; Operating The Base Station On - Siemens Gigaset C450 User Manual

When the alarm clock rings...
Alarm repeat after 5 minutes
Press the display key or any key.
§Snooze§
If you press three times the alarm clock
§Snooze§
switches off for 24 hours.
Switching off the alarm clock for 24 hours
Press the display key.
§Off§
Restoring the handset default
settings
You can reset any individual settings and
changes that you have made. This will not
affect entries in the directory, calls list, or SMS
lists or the handset's registration to the base
station.
¢ ¢
Settings Handset
§Menu§
Press the display key to confirm.
§OK§
a
Press and hold (idle status).
Cancel the reset with

Base station settings

The base station settings are carried out using a
registered Gigaset C45 handset.
Changing the system PIN
You have to enter the system PIN when register-
ing a handset to the base station.
You can change the base's 4-digit default sys-
tem PIN ("0000") to a 4-digit PIN known only to
yourself.
¢ ¢
Settings Base
§Menu§
~
Enter your new system PIN and
press
§OK§
shown as four stars ( **** ).
a
Press and hold (idle status).
Restoring the base station to
factory settings
When the settings are restored all handsets are
de-registered. Each individual setting is
restored. Only the date and time are retained.
¢
Reset Handset
a
.
¢
System PIN
. For security the PIN is
Resetting the base station using the menu
¢
Settings
§Menu§
Press the display key to confirm.
§OK§
Resetting the base station using a key on
the base station
¤
Remove the base station mains adapter
(page 4) from the power socket.
÷
Press the registration/paging key
(page 1)and hold down.
¤
Replug the mains unit into your power
socket.
÷
Continue to press the registration/
paging key (page 1).
¤
Release the registration/paging key
(page 1). The base station has now been
reset.

Operating the base station on

the PABX

The following settings are only needed when
your PABX requires them. Please refer to the
user guide for your PABX.
You cannot send or receive SMS messages on
PABXs that do not support Calling Line Identifi-
cation.

Dialling modes and flash time

Changing the dialling mode
You can set the dialling mode.
4 I O 1 1
§Menu§
~ 1
Pulse dialling mode (DP).
§OK§
Or:
~ Q
Touch tone dialling (DTMF).
§OK§
a
Press and hold (idle status).
Setting the flash time
You can set the flash time.
4 I O 1 2
§Menu§
~
Enter digits for the flash time and
press
Q
= 80 ms; 1 = 100 ms; 2 = 120 ms;
3 = 180 ms; 4 = 250 ms;
L M
= 600 ms; = 800 ms
a
Press and hold (idle status).
23
Base station settings
¢ ¢
Base Base Reset
.
§OK§
5
= 300 ms;