Download  Print this page

The Warming Drawer - Siemens HG2415UC, HG2416UC, HG2515UC, HG2516UC Use And Care Manual

Xtronic gas convection range.
Hide thumbs


Parts Key:
1. Stainless Steel Drawer Interior
2. Handle (HG25 models only)
3. Gasket
4. Rail Lock
About the Warming Drawer
The warming drawer will keep hot, cooked foods at
serving temperature.
Warming drawer settings are Low, Medium, and High.
Refer to the Warming Drawer Chart (next page) for
recommended settings.
To keep several different foods hot, set the temperature
to the food needing the highest setting.
Place item needing the highest setting toward the side of
the drawer and item needing less heat on the rack or in
the center of the drawer bottom.
Food should be at serving temperature (above 140° F)
before being placed in the warming drawer. DO
NOT use to heat cold food other than crisping crackers,
chips, and dry cereal, or warming dishes or
The warming drawer can be used with or without a rack.
Preheat with rack in place if using this arrangement. It
fits side to side.
Preheat empty serving dish while preheating drawer if
Place cooked, hot food in warming drawer in its original
cooking container or in a heat-safe serving dish.
Aluminum foil may be used to cover food; However DO
NOT line the warming drawer with aluminum foil.
DO NOT use the warming drawer for storage.
See next page for detailed instructions.

The Warming Drawer

Contact your dealer to order a warming drawer rack
Packaged Inside Drawer:
• Reversible Rack
Usable Space and Dish Sizes
Drawer Interior:
25"W x 17"D x5" H
Dish sizes:
2 - 9 x 13" Pyrex 3-quart dishes,
side by side.
2 - 9 1/2 x 15" Pyrex 4-quart
dishes, side by side.
4 - 10 1/2" plates, single or stacked
3 - 11" plates, single or stacked
The warming drawer has three settings: Low, Meduim
and High. The icons below are seen in the display when
the corresponding setting is selected:
Warming Drawer Rack
(HG25 models only)



   Related Manuals for Siemens HG2415UC, HG2416UC, HG2515UC, HG2516UC

This manual also for:


Comments to this Manuals

Symbols: 0
Latest comments: