Check Handset Functionalities; Start Up Not Successful; Check Lan Connection; Determine The Software Version - Siemens 2000 Administration Manual

Check handset functionalities

Check handset functionalities
•
•
•

Start up not successful

Check whether one or more of the mentioned questions are valid for your
configuration:
Is the optiPoint 410/420 being run in a
•
Is the optiPoint 410/420 being run behind a
•
Other configuration possibilities ...

Check LAN connection

•
•

Determine the software version

You can determine the version of the software that is running the
optiPoint 410/420, e.g., during a pending software update.
Check whether the plugs at the two ends of the handset cable are in-
serted correctly (handset engaged)
Carry out an Audio Loop test.
– More information on "Audio Loop Test"
– page 26
Ensure that the handset microphone is not switched off.
– For more information, see the operating instructions of the
optiPoint 410/420.
Enter the VLAN ID manually, or, if a
the "VLAN Method"
ferred from the DHCP server is used.
– More information on
page 22 page 53
Enter the IP address of the Gateway in
page 22 page 52
Check whether the plugs at the two ends of the LAN cable are correct-
ly inserted (handset engaged)
Check the connection with the help of the PING test.
– More information on "PING Test"
page 27 page 25
page 42
page 12.
VLAN ?
DHCP server is being used, set
page 81 on "DHCP" , so that the VLAN ID trans-
Default VLAN ID.
page 12.
page 74.
Administration scenarios
page 59.
Gateway?
Default Route.
91