Error Messages - Siemens 2000 Administration Manual

optiPoint 410 entry
Step by Step
LEDs on the phone:

Error Messages

The LEDs flash till you switch to the Administration
Mode page 32.
No IP address
The DHCP server cannot assign a terminal IP address
page 80.
Possible solution
Check the DHCP server.
No terminal screen
The DHCP server cannot assign a terminal screen
page 80.
Possible solution
Check the DHCP server.
No Default Route
The DHCP server cannot assign a default route
page 62.
Possible solution
Check the DHCP server.
No IP Address is set
The DHCP IP assignment
and no terminal IP address is configured.
Possible solution
Activate the DHCP IP assignment
Enter the terminal IP adress
Administration
page 62 is switched off
page 17.
page 17.
35